Exit Mould Trigger 500mL
Description
Exit Mould attacks moulds at the source and the special detergent additive helps leave the surface sparkling clean.
Can be used indoors and outdoors.
- Bathroom and laundry.
- Tiles, grout and walls.
- Rubber bath mats.
- Fridge door seals.
- Boats.
- Under eaves.
- Concrete patios.
- Most mouldy areas.
Ingredients
Sodium Hydroxide 2.4g/L Alkaline Salts 1.2g/L Sodium Hypochlorite 42g/L
Usage Instructions
1. Pointing trigger away from the face, hold down the safety tab on top of the nozzle. 2. Turn nozzle to "ON" position. Do not squeeze the trigger when it is in "OFF" position as this may cause it to spit when turned ON. 3. Spray from 20-30cm away from targeted area. Leave for 30s for light stains and 10 mins for tough stains. 4. Rinse with water and then wipe off. Repeat steps 2 to 4 if required. 5. When finished, turn nozzle to "OFF" position, until safety tab locks in position.